How to Get Mildew Off of Your Shower Curtain Rod

By The Shower Drapes | Blog

Disclaimer: There are affiliate links in this post. At no cost to you, I get commissions for purchases made through links in this post.

The best way to keep the inside of your home dry and germ free is to know how to get mildew off of shower curtain rods. Molds, algae, mildew and even viruses can all thrive in moist areas and it’s very important to get rid of these nasty organisms before they can begin to cause damage. The mildew, algae and other organisms all grow best when there is moisture present.

There are several ways to get mildew off of shower curtain rods and these range from using soap or warm water to removing the rod by hand. It’s important to remove the rod before the moisture builds up on the surface of the rod. If you wait too long the fungi and other organisms will start to grow, causing a permanent build up of buildup that is difficult to remove.

The first way to remove mildew from a rod is to treat it with soap and warm water. You should first soak the rod in the soap and then allow it to dry completely. If you follow this advice, you will soon notice that the rod will no longer be water logged but rather will look clean.

To help with the removal of mildew, try blotting the area to be treated with a towel or cloth. This is the most effective way to kill the buildup of mildew and mold spores. You can also remove mildew by rinsing the area with bleach and then washing the cloth in hot water.

By taking the rod apart you will be able to determine if it has mildew. Take a look at the rod for leaks and air bubbles. If there are no leaks and the rod is free of bubbles, it should be fine to treat with bleach. Dry it thoroughly and allow it to dry.

To do this, take a small towel or cloth and blot the area of the rod that you want to treat. To get the greatest effect you should spray the area with a household chemical or bleach solution. If you have several rods that need to be treated, make sure to treat each rod at least once so that you can prevent any future buildup.

As a precautionary measure, you should always make sure to inspect any item that has been exposed to moisture. Be sure to check to see if the moisture has gotten inside the shower stall, near the area where the rod has been, or on the outside of the rod. If you find signs of mildew, you can apply a little bleach to the area to destroy the mold and any remaining microorganisms.

If you find that mildew is already growing on the shower rod, you can use a detergent to kill the bacteria. You should be careful when using bleach on items as the chemical can easily damage metal and other fixtures in your home.

If the mildew hasn’t affected the rod, you can also use ammonia to disinfect the area. You can use the ammonia with a scrub brush and a sponge to remove the mildew. Never try to manually remove the mildew because it is often much more difficult to remove.

Since mildew is found on the surface of the rod, you should spray it down and allow it to dry completely. This way the mildew will not be able to penetrate into the wood of the rod and be able to continue to grow. The rod must be completely dry before you are able to actually replace the rod in your shower.

For repeated infestations, be sure to use a spray or a dry towel to remove the mildew. It’s important to keep the rod dry and the shower dry so that you don’t have to pay for damages caused by the fungus and mildew. If you notice that the mildew has grown into the wood of the rod or into the shower panels, you should replace the entire rod.

Homes with showers don’t have to be an unpleasant place to live in because there are many different solutions to cleaning and keeping your homes safe from mildew and fungus. Once you figure out the type of mildew you have, be sure to clean the rod immediately and begin removing the mildew.

About the Author

Meet Our Sponsors

Knee Support for Running

Medical Supplies Wholesale Pharmacy Store

Lumultra: Brain Pills That Can Make You Smarter